The MAINS plug is used as the disconnect device, the disconnect device shall remain readily operable.

You can now repeat the same process for other channels if you wish.

The Helix Board 18 FireWire features a total of 3 microphones with standard XLR male connectors, AUX Sends.

Located on the rear of the Helix Board 18 FireWire, Please use the power cable that is included the primary use for these TRS phone jacks is for with this mixer only.

An on button and indicator also accompanies this control, allowing users to mute and activate the channel at will.

It sends, where the first is in fact a 60mm couldnt be simpler.

Pushing the on button in activates the equalizer, which is accompanied by an illuminated LED.

Either select a new destination for the installation, or else click Next to accept the default directory.

Phonic Helix Board 18 Firewire Free To Use

After installation is complete, users are free to use the device as they wish.

Phonic Helix Board 18 Firewire Manual By Go

If you would like to use the Helix Board 18 FireWire For further instructions on the operation of as your default audio output device on you PC, simply Cubase, please consult the user manual by go into the Windows control panel, and select Sound.

When the sampling In the Streams section, the Helix Board 18 FireWire rate is manually set, users can select between device properties can be viewed.

Each input and sampling rates of 44.1, 48.0, 88.2 and 96.0 kHz per.

The amount of feedback 100 ms (600bpm) is adjusted using the PARAMETER Delay Time 2690 ms (22.3bpm) control.

PHONIC CORPORATION Helix Board 18 FireWire Users Manual.

Phonic Helix Board 18 Firewire Driver